Control GPIOs of NodeMCU (ESP8266) with ESP8266 co.Control GPIOs of NodeMCU (ESP8266) with ESP8266 core for Arduino, to read Buttons and write LEDs the loop function runs over and over again forever the setup function runs once when you press reset or power the board * report error of: 'D1' was not declared in this scope. * For others, such as "Generic ESP8266 Module", it will * For NodeMCU (8266) both D1 and 5 refer to the same pin No support for open-drain/interrupt/pwm/i2c/ow. D0(GPIO16) can only be used as gpio read/write.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |